The "Buon Vino Mini Jet Electric Filter" has been designed with the small quantity winemaker in mind. It is the perfect way for the home hobbyist to produce a wine with a commercial shine. Perfect for the home winemaker who filters 23 liters (6 USG) at a time from kits.

INSTRUCTIONS
Once you have started filtering DO NOT filter more than 10 gallons or 50 litres of wine at a time. If you have additional wine to be filtered you MUST allow the motor to cool for 45 minutes to 1 hour before commencing filtration.

IMPORTANT DO NOT LET THE PUMP RUN DRY.
IMPORTANT: WINE MUST RE RACKED OR DECANTED AT LEAST ONCE DURING THE NORMAL PROCESS OF WINE MAKING.

NOTE: PRIOR TO FILTERING, RACK YOUR WINE INTO A NEW CONTAINER.

INSTRUCTIONS FOR USE

1) READ FILTER PAD DIRECTIONS AND MOTOR DIRECTIONS FIRST.
2) Remove the pads from the package and place them in a clean container with enough fresh water to cover the pads and allow them to soak (approx. 5 min.) Make sure pads are not bunched together while soaking, allow the water to saturate on both sides of the 3 pads.
3) Attach the small diameter piece of hose supplied, to the fitting located under the drip tray. ("A" on diagram). This same hose is used for racking and cleaning your pump.
4) Loosen the two black hand wheels and remove the two central plates.
5) Remove the pads from the water and begin inserting them into the filter body. The course side will be facing the hand wheels and the holes will be aligned See diagram. The pads have a tight fit. Make sure to press down on the pad so that both sides of the "T" are sitting on the two side bolts and the pad is straight along the top.
Place the pad into the filter body, next place one of the central filtering plates, insert the second pad and the next plate in the same manner, followed by the last pad. Once the pads and the plates are inserted all the pads and the plates should be even along the top.

NOTE: The pads are cut in a "T" formation with one side of the "T" higher than the other. The hooks on both sides of the filter plates also have the same offset. This allows you to insert the pads and plates properly.

6) Tighten the hand wheels to ensure a tight seal on the pads.
7) Insert the intake hose, which contains a stainless steel wire and a red anti-sediment tip to the inlet on the pump. (B on the diagram.)
8) Insert the long slightly larger diameter, out-take lube onto the exit nozzle (C on the diagram)
9) Place the intake tube into the wine to be tittered. Next place your out-lake tube and the small tube attached to the drip tray into your container which will hold your tittered wine.
Upon commencing your filtration lie wine will push out the water that remains in the pad via your out take lube. Allow the water to flow out prior to placing the hose into the container which will hold your filtered wine. It you desire, you may place the tube attached to the drip tray into a separate container and re-titter this wine at the end.
10) You are now ready to filter. Plug in the cord and turn on the switch located at the rear at the filter.
11) The pump may initially be dry, and will not draw the wine quickly. If this happens force some wine using the intake tube, into the pump.
12) For you convenience you may use the pump tor racking. For set up, follow the same directions as suggested tor cleaning your pump (bypassing the filter plates)